Free NCP-MCI-6.5 Exam Dumps

An administrator is configuring data protection and DR for a multi-tier application. All VMs must be protected at the same time.
What must the administrator do to meet this requirement?

Correct Answer:B
According to the web search results, a consistency group is a group of related applications or services that must be recovered together in order to work properly,
and this means more than being recovered at the same time67. They also typically need to be recovered to the same point in time6. Therefore, to meet the requirement of protecting all VMs of a multi-tier application at the same time, the administrator must create a consistency group for the application and place all VMs in it8. This way, the administrator can apply data protection policies and schedules to the entire consistency group as a single unit8.

What is the minimum time a newly created Deduplication storage policy takes to apply to the VMs in the container?

Correct Answer:C
https://portal.nutanix.com/page/documents/details?targetId=Prism-Central- Guide-vpc_2023_3:mul-cluster-storage-policy-pc-c.html

Refer to the exhibit.

An administrator is trying to implement the solution that is shown in the exhibit, but has been unsuccessful.
Based on the diagram, what is causing the issue?

Correct Answer:C
The correct answer is C. Network latency.
The diagram shows a solution that uses synchronous replication between two remote protection domains, cluster site A and cluster site B. Synchronous replication is a feature that allows near-zero RPO (recovery point objective) by replicating data to the remote site before acknowledging writes to the local site. However, synchronous replication has some requirements and limitations that must be met for it to work properly. One of these requirements is that the network latency between the two sites must be less than or equal to 5 ms1. If the network latency is higher than 5 ms, the synchronous replication will fail and the protection policy will be suspended2.
Therefore, based on the diagram, the most likely cause of the issue is that the network latency between cluster site A and cluster site B is higher than 5 ms, which prevents the synchronous replication from working. To verify this, the administrator can use the ??ncli cluster ping?? command to measure the network latency between the two sites3. If the network latency is indeed higher than 5 ms, the administrator can either improve the network performance or switch to a different replication mode, such as near-synchronous or asynchronous.
Reference: Synchronous Replication Requirements

Which two capabilities does IPAM provide in a Nutanix networking configuration? (Choose two.)

Correct Answer:BC
According to the Nutanix Support & Insights, IPAM enables AHV to assign IP addresses automatically to VMs using DHCP. You can configure each virtual network and associated VLAN with a specific IP subnet, associated domain settings, and group of IP address pools
available for assignment.

AHV IPAM assigns an IP address from the address pool when creating a managed VM NIC.
At which two instances does the address release back to the pool? (Choose two)

Correct Answer:BD
https://portal.nutanix.com/page/documents/solutions/details/?targetId=BP-2029_AHV:BP-2029_AHV
Administrators can use Acropolis with IPAM to deliver a complete virtualization deployment, including network management, from the unified Prism interface. This capability radically simplifies the traditionally complex network management associated with provisioning VMs and assigning network addresses. To avoid address overlap, be sure to work with your network team to reserve a range of addresses for VMs before enabling the IPAM feature. The Acropolis master assigns an IP address from the address pool when creating a managed VM NIC; the address releases back to the pool when the VM NIC or VM is deleted.