Free JN0-683 Exam Dumps

No Installation Required, Instantly Prepare for the JN0-683 exam and please click the below link to start the JN0-683 Exam Simulator with a real JN0-683 practice exam questions.
Use directly our on-line JN0-683 exam dumps materials and try our Testing Engine to pass the JN0-683 which is always updated.

Exam Code: JN0-683
Exam Title: Data Center - Professional (JNCIP-DC)
Vendor: Juniper
Exam Questions: 65
Last Updated: March 9th,2026

Question 1

Exhibit.
JN0-683 dumps exhibit
Referring to the exhibit, why is the active source field blank for the entry that uses the 00:0c:29:e8:b7:39 MAC address?

A. The EVPN route for this host does not have a valid next hop.
B. The ARP lookup for this host has failed.
C. The host for this entry is locally connected to leaf1.
D. This entry is associated with a multicast EVPN route.

Correct Answer:C

Question 2

You are preparing an sFlow monitoring system configuration.
In this scenario, what Information will be included in the datagram sent to the sFlow collector? (Choose two.)

A. the interlace through which the packets entered the agent
B. the sending device's serial number
C. the CRC from the sampled packet
D. the source and destination VLAN for sampled packets

Correct Answer:AD

Question 3

You are asked to interconnect two of your company's data centers across an IP backbone. Both data centers require Layer 2 and Layer 3 connectivity. In this scenario, which three actions would accomplish this task? (Choose three.)

A. Advertise Type 2 EVPN routes across the DCI.
B. Ensure border leaf nodes in each data center can exchange EVPN routes.
C. Ensure there is a full mesh of VTEPs between all spine nodes within both data centers.
D. Advertise Type 5 EVPN routes across the DCI.
E. Ensure there is a full mesh of VTEPs between all leaf nodes within data centers.

Correct Answer:ABD

Question 4

You want to convert an MX Series router from a VXLAN Layer 2 gateway to a VXLAN Layer 3 gateway for VNI 100. You have already configured an IRB interface. In this scenario, which command would you use to accomplish this task?

A. set protocols isis interface irb.100 passive
B. set vlans VLAN-100 13-interface irb.100
C. set bridge-domains VLAN-100 routing-interface irb.100
D. set protocols ospf area 0.0.0.0 interface irb.100 passive

Correct Answer:C

Question 5

You are deploying a new network lo support your Al workloads on devices that support at least 400 Gbps Ethernet. There is no requirement for any Layer 2 VLANs in this network. Which network architecture would satisfy this requirement?

A. an IP fabric using PIM-SM to signal VXLAN overlay
B. an IP fabric using the EVPN-MPLS architecture
C. an IP fabric with an EVPN-VXLAN architecture
D. an IP fabric using EBGP

Correct Answer:D