Free FCSS_SDW_AR-7.4 Exam Dumps

No Installation Required, Instantly Prepare for the FCSS_SDW_AR-7.4 exam and please click the below link to start the FCSS_SDW_AR-7.4 Exam Simulator with a real FCSS_SDW_AR-7.4 practice exam questions.
Use directly our on-line FCSS_SDW_AR-7.4 exam dumps materials and try our Testing Engine to pass the FCSS_SDW_AR-7.4 which is always updated.

Exam Code: FCSS_SDW_AR-7.4
Exam Title: FCSS - SD-WAN 7.4 Architect
Vendor: Fortinet
Exam Questions: 38
Last Updated: March 9th,2026

Question 1

Exhibit.
FCSS_SDW_AR-7.4 dumps exhibit
Which action will FortiGate take if it detects SD-WAN members as dead?

A. FoftiGate bounces port5 after it detects all SD-WAN members as dead.
B. FortiGate fails over to the secondary device after it detects port5 as dead.
C. FortiGate sends alert messages through poft5 when it detects all SD-WAN members as dead
D. FortiGate brings down port5 after it detects all SD-WAN members as dead.

Correct Answer:D

Question 2

Refer to the exhibits.
FCSS_SDW_AR-7.4 dumps exhibit
The exhibits show the source NAT (SNAT) global setting. port2 interface settings, and the routing table on FortiGate.
The administrator increases the member priority on port2 to 20.
Upon configuration changes and the receipt of new packets, which two actions does FortiGate perform on existing sessions established over port2? (Choose two.)

A. FortiGate continues routing all existing sessions over port2.
B. FortiGate routes only new sessions over port2.
C. FortiGate flags the SNAT session as dirty only if the administrator has assigned an IP pool to the firewall policies with NAT.
D. FortiGate flags the sessions as dirty.
E. FortiGate updates the gateway information of the sessionswith SNAT so that they use port1instead of port2.

Correct Answer:DE

Question 3

You are planning a large SD-WAN deployment with approximately 1000 spokes and want to allow ADVPN between the spokes. Some remote sites use FortiSASE to connect to the company's SD-WAN hub. Which overlay routing configuration should you use?

A. BGP on loopback with dynamic BGP for ADVPN shortcut routing.
B. BGP on loopback with IPsec phase2 selectors for ADVPN shortcut routing.
C. BGP per overlay with dynamic BGP for ADVPN shortcut routing.
D. BGP per overlay with BGP next-hop convergence for ADVPN shortcut routing.

Correct Answer:A

Question 4

Which two statements correctly describe what happens when traffic matches the implicit SD-WAN rule? (Choose two.)

A. The session information output displays no SD-WAN service id.
B. Traffic is load balanced using the algorithm set for the v4-ecmp-mode setting.
C. The traffic is distributed, regardless of weight, through all available static routes.
D. Traffic does not match any of the entries in the policy route table.
E. FortiGate flags the session with may_dirty and vwl_def ault.

Correct Answer:AD

Question 5

Which statement describes FortiGate behavior when you reference a zone in a static route?

A. FoftiGate installs ECMP static routes for the first two members of the zone.
B. FortiGate ignores the static routes defined through members referenced in the zone.
C. FortiGate routes the traffic through the best performing member of the zone.
D. FortiGate installs a static route for each member in the zone.

Correct Answer:D