Free 2V0-41.24 Exam Dumps

Question 11

Which CLI command shows syslog on NSX Manager?

A. (show log manager follow
B. gee log-file syslog
C. [get log-file auch.log
D. /var/log/syslog/syslog.log

Correct Answer:A
The show log manager follow command is used on the NSX Manager to view the syslog in real-time. This command displays ongoing log entries, allowing administrators to monitor syslog messages as they are generated, which is helpful for troubleshooting and real-time analysis.

Question 12

How does the Traceflow tool identify issues in a network?

A. Compares intended network state in the control plane with Tunnel End Point (TEP) keepalives in the data plane.
B. Compares the management plane configuration states containing control plane traffic and error reporting from transport node agents.
C. Injects ICMP traffic into the data plane and observes the results in the control plane.
D. Injects synthetic traffic into the data plane and observes the results in the control plane.

Correct Answer:D
The Traceflow tool in NSX injects synthetic traffic into the data plane and monitors the traffic flow through the network, allowing administrators to observe how the traffic is handled at each hop. This approach helps identify issues such as dropped packets, routing errors, or misconfigurations by providing visibility into the path taken by the traffic and any potential disruptions.

Question 13

Which two statements are correct about East-West Malware Prevention? (Choose two.)

A. A SVM is deployed on every ESXi host.
B. NSX Application Platform must have Internet access.
C. An agent must be installed on every ESXi host.
D. An agent must be installed on every NSX Edge node.
E. NSX Edge nodes must have Internet access.

Correct Answer:AB
Reference: https://docs.vmware.com/en/VMware-NSX-T-Data- Center/3.2/administration/GUID-0A8BF7D8-9C2E-48A5-8219-17C00F1EC13A.html https://www.wwt.com/blog/primer-series-napp-malware-prevention

Question 14

Which command is used to display the network configuration of the Tunnel Endpoint (TEP) IP on a bare metal transport node?

A. debug
B. tcpdump
C. tcpconfig
D. ifconfig

Correct Answer:D
The ifconfig command is used to display the network configuration of interfaces, including the Tunnel Endpoint (TEP) IP on a bare metal transport node. This command provides details about IP addresses, subnet masks, and other network settings for each interface on the node.

Question 15

How is the RouterLink port created between a Tier-1 Gateway and Tier-0 Gateway?

A. Automatically created when Tier-1 is created.
B. Manually create a Logical Switch and connect to bother Tier-1 and Tier-0 Gateways.
C. Manually create a Segment and connect to both Tier-1 and Tier-0 Gateways.
D. Automatically created when Tier-1 is connected with Tier-0 from NSX Ul.

Correct Answer:D
The RouterLink port between a Tier-1 Gateway and a Tier-0 Gateway is automatically created when the Tier-1 Gateway is connected to the Tier-0 Gateway through the NSX UI. This link enables routing between the Tier-1 and Tier-0 gateways without the need for manual configuration of segments or logical switches.